Betekenis van:
shoulder joint

Voorbeeldzinnen

1. The joint of my left shoulder aches.
2. Height of shoulder joint 135 cm
3. 15 cm Height of shoulder joint 135 cm
4. For the purpose of this Directive, a hip, knee or shoulder replacement means an implantable component part of a total joint replacement system which is intended to provide a function similar to that of either a natural hip joint, a natural knee joint or a natural shoulder joint.
5. on the reclassification of hip, knee and shoulder joint replacements in the framework of Council Directive 93/42/EEC concerning medical devices
6. For these reasons, it is necessary to proceed to the reclassification of hip, knee and shoulder total joint replacements as class III medical devices.
7. Hip, knee and shoulder replacements should be distinguished from other total joint replacements, due to the particular complexity of the joint function to be restored and the consequent increased risk of failure due to the device itself.
8. Commission Directive 2005/50/EC of 11 August 2005 on the reclassification of hip, knee and shoulder joint replacements in the framework of Council Directive 93/42/EEC concerning medical devices (OJ L 210, 12.8.2005, p. 41).
9. Commission Directive 2005/50/EC of 11 August 2005 on the reclassification of hip, knee and shoulder joint replacements in the framework of Council Directive 93/42/EEC concerning medical devices (OJ L 210, 12.8.2005, p. 41).’
10. Commission Directive 2005/50/EC of 11 August 2005 on the reclassification of hip, knee and shoulder joint replacements in the framework of Council Directive 93/42/EEC concerning medical devices [2] is to be incorporated into the Agreement,
11. Member States shall accept until 1 September 2010 the placing on the market of hip, knee and shoulder replacements which are covered by a Decision in accordance with Articles 11(3)(b)(iii) of Directive 93/42/EEC issued before 1 September 2007 and permit such total joint replacements to be put into service beyond that date.
12. It is necessary to provide for an adequate transitional period for hip, knee and shoulder total joint replacements already assessed as class IIb medical devices under the full quality assurance system of Annex II to Directive 93/42/EEC, allowing for their complementary assessment under point 4 of Annex II to the Directive.
13. Hip, knee and shoulder total joint replacements already certified following the procedure relating to the EC type examination set out in Annex III to Directive 93/42/EEC, coupled with the procedure relating to the EC verification set out in Annex IV or the procedure relating to the EC declaration of conformity set out in Annex V to that Directive, are not affected by the present Directive as these certification schemes are the same for both class IIb and class III medical devices.
14. It is necessary to provide for an adequate transitional period for hip, knee and shoulder total joint replacements that have already been subject to the procedure relating to the EC type examination under Annex III to Directive 93/42/EEC coupled with the procedure relating to the EC declaration of conformity set out in Annex VI to that Directive, allowing for their assessment under Annex IV or Annex V to Directive 93/42/EEC.
15. ‘carcases of bovine animals’, for the purposes of subheadings 020110 and 020210: whole carcases of the slaughtered animals after having been bled, eviscerated and skinned, imported with or without the heads, with or without the feet and with or without the other offals attached. Where carcases are imported without the heads, the latter must have been separated from the carcase at the atloido-occipital joint. When imported without the feet, the latter must have been cut off at the carpo-metacarpal or tarso-metatarsal joints; ‘carcase’ shall include the front part of the carcase comprising all the bones and the scrag, neck and shoulder, having more than 10 pairs of ribs;